3140RAL620
The 3140RAL620 Joystick, also known as Gain, is the perfect tool for precise control. With a voltage of 40xV, it ensures accurate and responsive movements. Its Limiter feature, or Limiteur in French and Limiter in German, allows you to set boundaries and prevent excessive movements. The round shape of the Joystick's Limiter ensures smooth and effortless adjustments. Equipped with a comfortable Handle, or Poignée in French and Handgriff in German, you can navigate with ease and comfort. The inclusion of a Third Axis, or 控制杆 in Chinese, adds an extra dimension to your control capabilities. The Joystick's Bezel, or Facette in French and Gehäuse in German, features a square drop-in design, making it easy to install and integrate into your setup seamlessly.
Key Features
- Series: 3
- Handle: Third Axis
- Handle: AL
- Modifier: Guided Feel
- Bezel: Square (drop-in)
- Gain: ±40%xV
- Limiter: Round
- Configuration: Standard
Specifications
Distinctive Features:
- One, two or three axis
- Analog or PWM outputs
- Low profile less than 20 mm below panel depth
- 5 V or 3.3 V operation
- Metal mechanism
General Specifications:
- Life Cycles: 10,000,000 cycles (5,000,000 for 3 axis joysticks)
- Seal Above Panel: IP66 (dependant on configuration)
Environmental Specifications:
- Operating Temperature: -25ºC to 70ºC (-13ºF to 158ºF)
- Storage Temperature: -40ºC to 70ºC (-40ºF to 158ºF)
- EMC Emission: Complies with EN 61000-6-3:2001, CISPR 22:2005, Class B 30MHz–11GHz
- ESD: Complies with EN61000-4-2 (extended) ±8KV (20 contacts) & ±15KV (20 air discharges)
- EMC Immunity: 100V/m, 80MHz-2.7GHz, 1KHz 80% sine wave modulation, EN 61000-4-3 (extended)
- Vibration: 100Hz – 200Hz @ 0.13g /Hz, total 3.6gRMS (1 Hour in each of the three mutually perpendicular axis)
Electrical Specifications:
- Gain (Output Voltage Span): ±10% x V to ±50% x V
- Output at Center: V/2 ±(5% x Gain)
- Power Supply: 5V ±0.5V Transient free (Configs 1, 3, 4 & 5) or 3.3V ±0.1V (Config 2)
- Center Tap Impedance: 1K1
- Center Detect Output: Pulled high within joystick via 2K2 to +V, and smoothed to 0V with 100nF
- Sensor Type: Hall effect
- Analog PWM CAN J1939 & CANopen outputs
- Current Consumption: 5V <13mA (Two axis) <20mA (Three axis) 3.3V <24mA (Two axis) <40mA (Three axis)
- Loads: Minimum 10K, preferred 100K+
Added to Your Cart