FPBP1C1262C2213
FP 26 mm series illuminated pushbutton switches feature a dia. 26 mm bushing and snap-in mounting.
Key Features
- Series: FP
- Model: Snap-in, Ø 26 (1.023)
- Led Resistors: 24 VDC resistor
- Marking: Laser
- Terminals: Solder lugs
- Actuator Colors: Red
- Led Colors: Red
- Contact Mat: Silver
- Electrical Functions: OFF - ON
- Actuators: Round, flat
- Led Control And No Of Poles: Independent, 1 pole
- Bezel Colors: Black
- Symbols: Hazard warning (0085)
Specifications
Distinctive Features:
- Snap-in mounting
- Full actuator or symbol illumination
- Large but lightweight
- Pad printed or laser etched symbols
General Specifications:
- Panel thickness : 1,5 (.059) to 2 mm (.078) with panel gasket, 2 (.078) to 2.5 mm (.885) without panel gasket
- Total travel : 2.5 mm ± 0.5 mm
- Typical operating force : 8 N ± 2 N
- Low level or mechanical life : - Momentary models : 1 million cycles - Latching models : 200,000 cycles
Environmental Specifications:
- Front panel sealing : IP54 according to IEC 60529 with panel gasket and 2 mm panel thickness
- Operating temperature : -40 °C to +75 °C
Electrical Specifications:
- Max. current/voltage rating with resistive load : - silver contacts (code 2) : 4 A 12 VDC - gold plated contacts (code 4) : 200 mA 12 VDC
- Initial contact resistance : 50 mΩ max.
- Insulation resistance : 1 GΩ min. at 500 VDC
- Dielectric strength : 1,000 Vrms 50 Hz min.
- Electrical life at full load : - Momentary models : 1 million cycles (gold plated contacts), 400,000 cycles (silver contacts) - Latching models : 200,000 cycles
Materials:
- Case : PA46
- Actuator : PA12
- Bushing/ bezel : ABS
- Contacts : silver (code 2) or silver, gold plated (code 4)
Added to Your Cart